KINGSTON VALUERAM 8GB DDR4 3200MT/S NON-ECC UNBUFFERED SODIMM MEMORY RAM FOR LAPTOP

Kingston 8GB 3200MHz DDR4 Non-ECC CL22 SODIMM, is a specific model of laptop memory module (RAM).

Let's break down the terminology for better understanding:

Kingston: This is the manufacturer or brand of the RAM module.

Kingston is a well-known company that produces various types of memory and storage devices.

8GB: This refers to the capacity of the Random Access Memory (RAM) module.

8GB is a fairly standard amount of RAM for modern laptops and is suitable for most general use cases,

including browsing, streaming, and using office applications.

3200 MHz: This refers to the speed of the RAM module, measured in megahertz (MHz).

3200MHz is a good speed, which should allow for fast data transfer and good overall performance.

DDR4: This is the type or generation of Random Access Memory (RAM) module.

DDR4 is a newer and faster type compared to its predecessor DDR3.

It provides higher speed and efficiency.

Non-ECC: This means that the RAM module does not have an error-correcting code function.

ECC memory can detect and correct data corruption but is usually reserved for servers and other highly stable environments.

Non-ECC memory is standard for consumer laptops and desktops.

CL22: Represents the CAS response time of the RAM module.

It is a measure of the delay time between the moment the memory controller

tells the memory module to access a specific memory column in the RAM module and the moment data is available

from the specified array location on the module's output pins.

In this case, the CAS access time is 22 cycles, which is relatively high (lower values indicate faster access times).

SODIMM: This refers to the form factor of a random access memory (RAM) module.

SODIMM (small dual inline memory module) is a type of random access memory (RAM)
module used in laptops and other small computers.

It is smaller than the DIMMs used in desktop computers.

ValueRAM's KVR32S22S6/8

Is a 1Gx 64-bit (8GB) DDR4-3200 CL22 SDRAM (SynchronousDRAM),1Rx16, memory module
 based on four 1G x 16-bitFBGA components.

The SPD is programmed to JEDECstandard latency DDR4-3200
 timing of 22-22-22 at 1.2V.

This 260-pin SODIMM uses gold contact fingers.

The electrical and mechanical specifications are as follows:

• Power Supply: VDD = 1.2V Typical

• VDDQ = 1.2V Typical

• VPP = 2.5V Typical

• VDDSPD = 2.2V to 3.6V

• Nominal and dynamic on-die termination (ODT) for

 data, strobe, and mask signals

• Low-power auto self refresh (LPASR)

• Data bus inversion (DBI) for data bus

• On-die VREFDQ generation and calibration

• Single-rank

• On-board I2 serial presence-detect (SPD) EEPROM

• 8 internal banks; 2 groups of 4 banks each

• Fixed burst chop (BC) of 4 and burst length (BL) of 8

 via the mode register set (MRS)

• Selectable BC4 or BL8 on-the-fly (OTF)

• Fly-by topology

• Terminated control command and address bus

• PCB: Height 1.18” (30.00mm)

• RoHS Compliant and Halogen-Free